Eurotherm 3116 PID User's Guide download pdf (Page 34)

3100/3200 Series

32 Part No HA028651 Issue 3.0 Mar-06

6.1.3 To Select Access Level 3 or Configuration Level

Do This The Display You Should See Additional Notes

1. From any display press and hold



for more than 5 seconds

To Select Level 3

Lev 3

go to

CODE

The display will pass from the current operating level, for

example, Lev 1 to Lev 3 as the button is held down.

(If no button is then pressed for about 50 seconds the display

returns to the HOME display)

2. Press

▲

▼

to enter the

passcode for Level 3

code

The default code is 3:

If an incorrect code is entered the display reverts to ‘got o ’.

The controller is now in the level 3 will then revert to the

HOME display

3. When the LEV3 GOTO view is

shown, as in paragraph 1 above,

press

▲

to select ‘Conf’

To Select Configuration level

Conf

go to

CODE

Note:

▲

must be pressed quickly before the controller

requests the code for level 3

4. Press

▲

▼

to enter the

passcode for Configuration level

code

Conf

The default code is 4:

If an incorrect code is entered the display reverts to

‘goto’.

The controller is now in Configuration level will now show

Conf

5. Press and hold



for more than 3

seconds

6. Press

▲

to select the required

level eg LEV 1

To Return to a Lower Level

Conf

go to

Lev1

go to

The choices are:

LEV 1 Level 1

LEV 2 Level 2

LEV 3 Level 3

ConF Configuration

It is not necessary to enter a code when going from a higher

level to a lower level.

Alternatively, press



and scroll to the A cces list

header, then press



to select the required level.

The display will then flash ‘ConF’ for a few seconds and the

controller will then go through its start up sequence, starting

in the level selected.

Do not power down while Conf is flashing. If a power down

does occur an error message will appear – see section 12.4

‘Diagnostic Alarms’

☺

A special case exists if a security code has been

configured as ‘0’ If this has been done it is not necessary to

enter a code and the controller will enter the chosen level

immediately.

☺ When the controller is in configuration level the

ACCESS list header can be selected from any view by

holding down the



button for more than 3 seconds.

Then press



again to select ‘ACCES’

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 125 126

Comments to this Manuals

No comments

Eurotherm 3116 PID User's Guide Page 34

Comments to this Manuals

Related products and manuals for Processors Eurotherm 3116 PID