Eurotherm 3216i User's Guide download pdf (Page 39)

3216 User Guide Part No. HA027985ENG Issue 2.0 May 04

ENG

6.8 To Operate the Timer

If the timer is configured it can be operated in Level 1 or Level 2 as follows:-

Operation Action Indication

To Run the timer

Press and quickly release

▼

▲

Beacon -- RUN = On

Scrolling display - TIMER RUNNING

To Hold the timer

Press and quickly release

▼

▲

Beacon -- RUN = Flashing

Scrolling display - TIMER HOLD

To Reset the timer

Press and hold

▼

▲

for more than 1 second

Beacon -- RUN = Off

If the timer is a Dwell Type and configured to turn power

off at the end of the timing period OFF will be displayed

Timer has timed out

Beacon -- RUN = Off SPX = On if End Type = SP2

Scrolling display - TIMER END

To Reset the timer

after it has timed out

Press and hold

▼

▲

for more than 1 second

Beacon -- RUN = Off SPX = On if End Type = SP2

If the timer is a Dwell Type and configured to turn power

off at the end of the timing period OFF will be displayed.

To Cancel the ‘end’

output (if configured)

Press

If a logic (relay) output is configured to operate when the

timer has timed out, it can be cancelled by pressing these

two buttons (Ack)

Repeat the above to Run the timer again (Note: it is not essential to reset it after the End state is reached)

Note 1: When the timer has been reset, press

▼

▲

for more than 1second to select Auto/Manual mode.

Note 2: The time can be extended by changing the T.REMN parameter. If the timer has timed out it will automatically

run again.

Any output, not used for control, can be configured to operate while the timer is running and/or when it has timed out.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46

Comments to this Manuals

No comments

Eurotherm 3216i User's Guide Page 39

Comments to this Manuals

Related products and manuals for Carbon monoxide (CO) detectors Eurotherm 3216i