Eurotherm 3216i User's Guide download pdf (Page 30)

4.1.1 To Re-Enter Quick Code Mode

4.2 Pre-Configured Controller or

Subsequent Starts

If you need to re-enter the ‘Quick Configuration’

mode this can always be done as follows:-

A brief start up sequence consists of a self test in

which all elements of the display are illuminated and

the software version number is shown.

1. Power down the indicator

The indicator will briefly show the quick codes

during start up, then proceed to Operator Level 1.

2. Hold



button down and power up the

indicator again. Keep the button pressed until

you are requested to enter a passcode.

You will see the display shown below. It is called

the HOME display.

3. Enter a passcode using the

32h8i example

Process Value

Message Centre

buttons. In a new indicator the passcode

defaults to 4. If an incorrect passcode is

entered you must repeat the whole procedure.

☺ Parameters may also be configured using a

deeper level of access. This is described in the

3200i Engineering Handbook Part No. HA029006.

This may be downloaded from

www.eurotherm.co.uk.

Status Beacons

☺ If the Quick Codes do not appear during start up,

this means that the indicator has been configured in

a deeper level of access, see previous note. The

quick codes may then not be valid and are therefore

not shown.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 45 46

No comments

Eurotherm 3216i User's Guide Page 30